Royal Crown Sinnet
The Royal Crown Sinnet is the product of Crown Knots and
Wall Knots stacked on top of one another. Thicker than most 4-strand
sinnets, the tie’s interlocking parallel lines are accentuated by the
contrasting cords used.
Cord Used: Two 6 ft. (1.8 m) Cords = 3.5 in. (8.9 cm) Key Fob
Component Parts: Crown Knots + Wall Knots (Uncollapsed) + Contrasting Cords.
3.Flip the piece over, vertically, slide your forefinger into the loop, and extend the second cord laterally.
14.Arch the left and right cord ends over the cords below, in opposite directions, left cord above right.
16.Weave the upper cord end over the arch below it and through the crook of the second arch. Tighten the knot firmly.
Cord Used: Two 6 ft. (1.8 m) Cords = 3.5 in. (8.9 cm) Key Fob
Component Parts: Crown Knots + Wall Knots (Uncollapsed) + Contrasting Cords.
3.Flip the piece over, vertically, slide your forefinger into the loop, and extend the second cord laterally.
14.Arch the left and right cord ends over the cords below, in opposite directions, left cord above right.
16.Weave the upper cord end over the arch below it and through the crook of the second arch. Tighten the knot firmly.
Comments
Post a Comment